 Here's
a shot of the very first progress on Hooloovoo 1.2. I've basically taken
off the steel plate, getting ready for the Titanium that should arrive
soon, and I've hooked up my 3 channel Rx. |
 This
is just a close up of the 3 channel Rx... nothing big. |
 Here's
the Titanium from Titanium
Joe. it's a piece 9" x 23.75" x 1/8" for $76. |
 And
here... if I still had the full size pic, you'd be able to tell I was in
the middle of drilling the holes in the Ti. |
 And
also here, you'd be able to tell that the new Ti plate and the old steel
one are exactly alike if I had the full size pic... |
 Tapping
the Ti... |
 cutting
Ti with lots of pretty, pretty white sparks. |
 The
plate.. polished and tapped. |
 mounted
and looking purty |
 Here's
Hooloovoo right after I finished him for LTRC. |
 woohoo..
finally a full size pic... This is the Ti plate, after being polished by
Cat Scratch at LTRC. |
 close
up of the edge that Cat Scratch rounded |
 post
LTRC.. a lot less battle scars this time. |
 Hey,
look! another pic of damage from Mangle Gore... a little more noticeable
this time, though! =P Also, the scratches are from Cat Scratch. |
woohoo..
finally a full size pic... This is the Ti plate, after being polished by
Cat Scratch at LTRC.
close
up of the edge that Cat Scratch rounded
post
LTRC.. a lot less battle scars this time.
Hey,
look! another pic of damage from Mangle Gore... a little more noticeable
this time, though! =P Also, the scratches are from Cat Scratch.